IP Protection Elevator

IP防護等級電(diàn)梯

IP protection elevator is mainly used in the places including coal-fired power plant, cement factory, refinery and mine etc, as well as the dam with water and humid environment and hydropower station etc. This elevator uses permanent magnet plus driving force with the frequency variance, guaranteeing the comfort in the operation of the elevator. The special 32-digit computer system, CAN bus signal transmission and strong performance of anti-disturbance can be applicable into various worse working conditions. Various main components adopt high IP protection levels, guaranteeing the security and reliability in usage.

Introduction

Unique signal acquisition

By using the unique double line carrier transmission mode, the command signal of the car is connected with the control of the system reliably, which avoids the disadvantages of the multi angle angle transmission which is usually used in the oblique elevator. The signal transmission is reliable, the failure rate is low, the maintenance is free, and the well path signal adopts the bus four wire serial transmission mode.

Intelligent door machine

Keep track of the running track of the intelligent elevator door machine, thereby changing the relative position of the elevator door knife, ensure the reliable connection and the stop door knife gateball layer.

Car signal control

The battery powered by DC high performance maintenance, control integration door machine, and the barge stop seat type automatic charging way to supplement the energy of the battery, the whole car, only two safety loop connection cable and control system (with standard regulations), car lighting and ventilation are use the battery power supply, emergency call also uses audio carrier technology to achieve.

Parameter Table

Rated load	Drag method	Rated speed	Net dimension of car		Dimension of door opening		Dimension of hoistway		Dimension of machine room			Over head	Pit depth
Rated load	Drag method	Rated speed	Width	Depth	Width	Height	Width	Depth	Width	Depth	Height	Over head	Pit depth
kg		m/s	A	B	E	F	C	D	R	T	H	Q	P
Rated load	Drag method	Rated speed	Net dimension of car		Dimension of door opening		Dimension of hoistway		Dimension of machine room			Over head	Pit depth
Rated load	Drag method	Rated speed	Width	Depth	Width	Height	Width	Depth	Width	Depth	Height	Over head	Pit depth
kg	V V V F	m/s	A	B	E	F	C	D	R	T	H	Q	P
1000		0.5/1.0	1500	1800	1300	2100	2400	2100	3500	3500	2600	4300	1400
1600		0.5	2000	2000	1500	2200	2800	2350	3500	4000	2600	4400	1400
2000		0.5	2000	2400	1600	2200	2950	2750	3500	4500	2600	4500	1400
3000		0.5	2500	2600	2000	2200	3600	2950	4300	4700	2800	4500	1400
5000		0.25/0.5	3000	3300	2600	2400	4450	3650	5500	5500	2800	4800	1500/1600

Details PC version

Standard Function

Standard Function	Function Description
>Brake detection and protection	Open and closed through real-time monitoring of the brake brake arm detection switch. When the brake is not required when opened. The system will not allow the elevator.
>The correction speed and the number of floors of station	The system in operation is detected in the end station after the switch. The elevator will force the speed and automatic correction of floor display.
>Limit protector	The system detects the limit switch action, will immediately stop the elevator running.
>Maximum protection	The system detects the limit switch action, the whole system will immediately power down.
>Overspeed protection	When the elevator up and down more than 1.2 times the rated speed, cut off the control power supply, the elevator will stop running.
>Layer station floor, direction display	The station shows the elevator floor and the direction to be run.